8d37f6dffd
Added sample SD card files for Prusa i3 Updated sample CoreXY config.g file Updated IAP files
30 lines
1.4 KiB
Text
30 lines
1.4 KiB
Text
; homeall file for use with dc42 Duet firmware on CoreXY printers
|
|
; This file assumes the endstop switches are at the low end of each axis.
|
|
; Reverse the X and Y movement for high-end switches.
|
|
; Adjust the bed upper and lower limits in config.g (M208 commands) to get the correct homing positions
|
|
|
|
G91 ; relative mode
|
|
G1 S1 X-240 Y-240 F3000 ; course home X or Y
|
|
G1 S1 X-240 ; course home X
|
|
G1 S1 Y-240 ; course home Y
|
|
G1 X4 Y4 F600 ; move away from the endstops
|
|
G1 S1 X-10 ; fine home X
|
|
G1 S1 Y-10 ; fine home Y
|
|
|
|
; If you are using a microswitch for Z homing, insert similar code for the Z axis here,
|
|
; but use lower feed rates suitable for your Z axis.
|
|
|
|
G90 ; back to absolute mode
|
|
|
|
; If you homed the Z axis using an endstop switch, you can insert a G92 command here to correct the height.
|
|
|
|
; The following code assumes you are using a Z probe to do Z homing. Remove it if you are using a microswitch.
|
|
; Adjust the XY coordinates in the following to place the Z probe over a suitable spot,
|
|
; preferably near the centre of the bed if your Z probe supports that
|
|
|
|
G1 X100 Y100 F2000
|
|
G30
|
|
; This file leaves the head at the zprobe trigger height so that you can slip a piece of paper under it and then do G0 Z0 to check the height.
|
|
; If you prefer to send the printer to X0Y0Z0, un-comment the following lines
|
|
;G1 X0 Y0 F5000
|
|
;G1 Z0
|