cd5af6c7b1
- Added support for M374 (save height map) and M375 (load height map) - Added M376 (set bed compensation taper height) - Added T parameter to G31 command - M500, M501 and M502 now use config_override.g instead of flash memory. The parameters saved and restored are: -- M307 auto tune results -- PID parameters, if you used M301 to override the auto tune PID settings -- Delta printer M665 and M666 settings -- G31 trigger height, trigger value and X and Y offsets - The M501 auto save option has been removed - Removed S and T parameters from M301 command. Use M307 command instead. - M301 with negative P parameter no longer sets bang-bang mode. Use M307 instead. - Added P parameter to the G31 command to specify Z probe type. This allows you to view the parameters for the Z probe(s) and to set parameters for a particular Z probe type without selecting that type. G31 P or G31 P0 prints the parameters of the currently-selected Z probe. - Z probe offsets are now applied during G30 probing with specified XY coordinates, including during delta auto calibration - Z probe recovery time is now applied from the end of the travel move just before probing - Fixed bad dive height when using G29 with a large trigger height - Fixed bad JSON message during printing when there were no active extruders - Added exception handlers and store a software reset code when an exception occurs - Fixed reset reason text because on the Duet WiFi a watchdog reset can look like an external reset - G30 S-1 how printes the stopped height - Implemented M401 and M402 |
||
|---|---|---|
| .. | ||
| Duet-0.6-0.8.5 | ||
| Duet-WiFi | ||