29185f7f68
Speed factor and extrusion factor changes now take effect 1 move earlier Default feed rate after reset increased to 3000mm/min M574 command now accepts E parameter to that active low Z probe switches can be used Bed compensation is cancelled if Z probe was already triggered at the start of a probe M20 S2 response now flags directories with a * prefix M408 command introduced as an alternative to M105 S2 and M105 S3 When cold extrusion is prevented, say which tool was affected in the error message Bug fix: if a drive was turned off manually after going into idle mode, when it was enabled again the current remained at 30% Bug fix: cold extrusion prevention did not work |
||
|---|---|---|
| .. | ||
| RepRapFirmware-1.00f-dc42.bin | ||
| RepRapFirmware-1.00l-dc42.bin | ||
| RepRapFirmware-1.00m-dc42.bin | ||
| RepRapFirmware-1.00n-dc42.bin | ||
| RepRapFirmware-1.00o-dc42.bin | ||
| RepRapFirmware-1.00q-dc42.bin | ||
| RepRapFirmware-1.04a-dc42.bin | ||
| RepRapFirmware-1.04b-dc42.bin | ||
| RepRapFirmware-1.04c-dc42.bin | ||
| RepRapFirmware-1.04e-dc42.bin | ||