/**************************************************************************************************** RepRapFirmware - Configuration This is where all machine-independent configuration and other definitions are set up. Nothing that depends on any particular RepRap, RepRap component, or RepRap controller should go in here. Define machine-dependent things in Platform.h ----------------------------------------------------------------------------------------------------- Version 0.1 18 November 2012 Adrian Bowyer RepRap Professional Ltd http://reprappro.com Licence: GPL ****************************************************************************************************/ #ifndef CONFIGURATION_H #define CONFIGURATION_H #define NAME "RepRapFirmware" #define VERSION "0.1" #define DATE "2012-11-18" #define LAST_AUTHOR "reprappro.com" #define ABS_ZERO -273.15 // Celsius #define INCH_TO_MM 25.4 #define HEAT_SAMPLE_TIME 0.5 // Seconds #define TEMPERATURE_CLOSE_ENOUGH 5.0 // Celsius #define TEMPERATURE_LOW_SO_DONT_CARE 40.0 // Celsius #define STANDBY_INTERRUPT_RATE 2.0e-4 // Seconds #define NUMBER_OF_PROBE_POINTS 3 #define Z_DIVE 5.0 // Height from which to probe the bed (mm) // Webserver stuff #define DEFAULT_PASSWORD "reprap" #define DEFAULT_NAME "My RepRap 1" /* Z PROBE CALIBRATION * Set = 1 to enable Z probe ADC output on SerialUSb */ #define CALIB_Z 0 #endif