Z axis min and max limits are now enforced if the axes have been homed
M665 command now shows the re-calculated delta radius and tower offsets
after auto-calibration
Initial and final RMS errors are now shown after delta auto-calibration
Pause/resume now mostly works when absolute extruder coordinates are
used
Doubled the maximum length of the SD card file listing that can be sent
to PanelDue
Implemented zpl's Network and PrintMonitor changes including M404
(thanks, zpl)
Increased default maximum instantaneous speed changes
Bug fix:: if M226 was used to pause the print, the resume coordinates
were not set up correctly
Bug fix: when changing the travel direction, the head was sometimes
slowed down more than necessary
Bug fix: warm-up time was not shown correctly in DuetWebControl
Bug fix: extruder drive positions were always shown as 0.0 in
DuetWebControl
Bug fix: incorrect PID parameters were shown in response to M301
Replaced old web interface files on SD card by DuetWebControl
Modified all resume.g files to set the speed when moving to the paused
head coordinates
M0 no longer turns motors off
Updated M18 and M84 as per zpl fork
Don't insist that user provides values for all 5 possible extruders in
M906 command
Added Ormerod 2 sys files
Updated web interface files
Bug fix: M92 command would only set extruder steps/mm if either 1 or 5
extruder steps/mm was provided
Bug fix: Z-homing or bed probing when axis compensation was enabled
caused the X and Y origins to shift
We now mark drives as not homed when we disable them
File info code now supports gcode files generated by Simplify3D
Updated SD card files to latest web interface
Added more comments to config.g
Head movement commands that were in the tfree files have been moved to
the tpre files, to work better when G10 nozzle offsets are used
file names into a structure created in RepRap that was too short for them. Result - buffer overflow misery. For the moment I've commented out the bit of code in ff.c that handles long names (look for the string ******), but this needs to be tracked down and dealt with properly.
1. Z home now moves home, rather than just setting the coordinate.
2. Wait for temps implemented.
Also the JSON requests for the g code filelist has been temporarily commented
out in reprap.htm. It was causing the firmware to hang sometimes. To be investigated.
Machine now prints nicely...
